2003-2006 Rear Driver 2 Pc Trail Arm and Center Skid Repair CMLH0306
Driver rear trail arm and skid plate repair kit for Jeep Wrangler 2003-2006
This set includes the trail arm repair piece and the center skid plate repair piece for the driver side. These are weld on pieces. Moderate welding skills required.
- The trail arm piece will fix the area in front of the rear axle on the driver side where rot typically occurs. It occurs because on your original frame there is a factory drilled access hole, which allows debris and water to enter and creates rust over time. Our design includes a drain hole to prevent this from happening again. Piece includes both upper and lower control arm mounts. Measures approximately 22" end to end.
- The skid plate piece is a full length repair piece that completely repairs the area in front of and behind the skid plate on the driver side. This piece gets attached to the frame and the transfer case and transmission get bolted to it. Hardware is included. Measures approximately 43 1/2" end to end.
- For the trail arm piece you will need to remove the bottom 2/3 of the frame rail, grind smooth, slide the piece over the remaining upper 1/3, then weld.
- For the skid plate piece you will need to cut out the lower 2/3 of your frame and sandwich the repair piece over the remaining upper 1/3. Align bolt holes then weld around the perimeter.
Please browse our store. All of our stock inventory items are listed. If you do not see what you need, just send us a detailed drawing and we will give you a price. Call 570-595-5000